Update

Since the blade decided to be symmetrical, I wanted to put some "balance" on it, by unbalacing it. So, I put a small breaker section near the bottom on one side, and had the guard extend out and up on the other.

The way I see it, it allows the user the option of choosing which way the sword is held, breaker out, or guard out.

I wanted more than just a plain blade, which is obvious from all the erased lines that are clearly visible. I'm still learning, so nya. Decided to do some simple vinework in the center of the blade. As far as I'm concerned, and short of a few necessary tweaks, the blade is done.

I still have the hilt to work out, though what I have is permanent, I just need to figure how I'm going to detail it. Maybe a simple wood grain, maybe something else. I haven't decided.

(C) Me, Nivek.